威灵顿新材料有限公司

...


	缝编织物和编织物的结构碳纤维织物的性能碳纤维加固特性加固工作程序为什么选择碳纤维材料碳纤维加固方式工业纺织品缝编无纺布

施工方法

1.Surface Preparation
Substrate must be prepared as per Wellington Repair Manual.Concrete and Masonry surfaces are sand lasted and cleaned. Cracks over 0.010" are epoxy injected and any other necessary repairs are made.

2.Apply Epoxy Primer
All areas to be bonded are primed with Wellington low viscosity epoxy primer. This strengthens the substrate and promotes excellent adhesion.

3.Impregnate Fabric
The fabric is pre-impregnated with Wellington epoxy resin using a fabric saturator which precisely controls the resin to fiber ratio.

4.Lay Fabric
The wet fabric is then applied to the surface with our specially
design roll laminator, which has a built in tension controller.

5.Wet out Fabric
To assure the fabric is completely saturated with epoxy, a roller is used to apply additional epoxy where needed .

6.Eliminate Air Voids
Fabric is pressed to the surface and air voids and excess epoxy are removed .

7.Cure Time
Let the Wellington cure for 7 days at ambient temperature for maximum
performance.

8.Top Coat
Wellington can be top-coated in a variety of colors for maintenance free protection and to match existing structure.